GWKB1070 : Window-Eyes Does Not Run Automatically After Installation

Product: Window-Eyes
Author: Aaron Smith
Date Added: 04/26/2007
Last Modified: 07/25/2007

Symptom: After installing Window-Eyes 6.1 with startup options set to load Window-Eyes automatically, Window-Eyes does not launch automatically.

Cause: Registry entries that Window-Eyes requires in order to launch automatically are not available.

Solution: Uninstall Window-Eyes using either the "Uninstall a program" option in the Control Panel, or using the Window-Eyes Emergency Removal utility located in the Advanced Options in the initial Welcome dialog that displays after a Window-Eyes 6.1 CD autoruns. Once Window-Eyes is uninstalled, reboot. Once the reboot is complete, re-install Window-Eyes 6.1. Once Window-Eyes 6.1 is re-installed, the startup options will behave as expected.
Rate this article 1 star. Rate this article 2 stars. Rate this article 3 stars. Rate this article 4 stars. Rate this article 5 stars. Did you find this article helpful? Please take a moment to rate it using the stars below. One star indicates the lowest rating, and five stars indicate the highest. Low ranking articles will be revisited, and their content revised.

Article Rating: 3 / 5

This article is rated 3 / 5 out of 5 stars.

This article has been accessed 5181 times.

If you feel this article is missing important information that is keeping it from obtaining a high rating, please contact support@gwmicro.com with your suggestions on how to improve it.