The GW-Info list is a discussion list, which can be very active with many messages per day. Any subscriber of the GW-Info list has the ability to post on-topic messages.
From:
John ChilelliSubject:
WE MS Word settingsDate:
Sat, Sep 26, 2009 12:13:56 pmHi all,
A good friend of mine needs to re-setup his MS Word 2003 settings for
WE to work proficiently. She says a lot of the words she wrote are
only partially there when she trys reading either line by line, or
one word at a time with the CTRL+right or left arrow commands. Can
someone please tell me where in the WE manual these settings are located?
Thanks,
J
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to gw-info@gwmicro.com so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
listserv@gwmicro.com and include leave gw-info in the body
of the message.
A good friend of mine needs to re-setup his MS Word 2003 settings for
WE to work proficiently. She says a lot of the words she wrote are
only partially there when she trys reading either line by line, or
one word at a time with the CTRL+right or left arrow commands. Can
someone please tell me where in the WE manual these settings are located?
Thanks,
J
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to gw-info@gwmicro.com so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
listserv@gwmicro.com and include leave gw-info in the body
of the message.




